993/996/997/Cayman/Boxster Adjustable Control Arm Links
If you’re serious about how your 993, 996, 997, Cayman, or Boxster handles, you should upgrade the rear suspension with adjustable control arm links. There are two major drawbacks to the factory links: 1) You can’t lower your car and maintain proper suspension geometry. The factory links create too much toe-in, which cannot be adjusted out, creating handling problems and excessive tire wear. 2) The factory links have rubber bushings, which make handling imprecise, especially in performance driving when suspension loads are highest.
Rennline adjustable control arm links solve both these problems. Manufactured from 6061 aluminum and feature a turnbuckle design that allows each arm to be lengthened or shortened as needed to restore proper suspension geometry on a lowered Porsche. The FK Teflon-lined rod end bearings ensure precision handling and lock in your car’s alignment settings, ensuring predictable cornering under all conditions. Unlike the competitors’ product, Rennline arms come with eccentric locks and new hardware so you can completely eliminate the factory setup, which is known to go out of adjustment under hard driving and ruin your car’s alignment.
Note: Two required per car. Picture may not reflect actual application.
Sealed Camber Kits and Monoball Strut Mounts
Under extreme conditions, such as road racing and Autocross, negative camber is required to keep as much of the tire’s contact patch on the road as possible. Stock suspension mounts will not allow you to achieve the necessary amount of negative camber required for this type of performance driving. Rennline’s adjustable camber plates incorporate FK spherical bearings and eliminate the indistinct feedback associated with factory rubber mounts. Unlike most camber plates, a dust shield is supplied to eliminate water and debris from entering your car through the elongated holes required for a wide range of adjustment. These camber plates are cnc machined from 6061 anodized aluminum and allow for a wide range of negative camber. Available for front and rear, stock and aftermarket struts. Come as a set of 2. Available for 964/993/996*/997*/Boxster*/Cayman*
*Rear Monoball Strut Mounts for 996/997/Boxster/Cayman are Tarrett units which are not sealed.
Rennline Camber Advantage Strut Brace
Accurate camber setting are a must for any track or performance street car. Adjusting camber from your camber plates usually requires a pry bar in one hand and your wrench in the other, giving you an end result of…… “close enough”. Those days are over. Not only is this the industries first 3 point strut brace for the 964/993, it also has an integrated adjustment point that will allow you to fine tune, then lock your camber settings in a matter of seconds. This feature will eliminate the need to drill and pin your camber plates to insure that they will not move under extreme race conditions. This strut brace is available in both 2 and 3 point configuration and is constructed from aluminum and stainless steel. Note: Will operate with most adjustable camber plates. This 964/993 Strut Brace can be installed on cars without adjustable camber plates, however the adjustment feature will not be functional. Available for 964/993
manufacturer's names, symbols and descriptions are
used for reference only. They do not imply that
any listed product is the product of these
manufacturers unless otherwise noted. Porsche,
Boxster, Carrera, Targa, and the Porsche Crest are
registered trademarks of Porsche